Oriental-laser is focused on diode laser hair removal machine manufacturer and after-sale service. So we will also teach each of our customer to do each handling of emergency in your side locally. For how to remove the plug when repairing the diode laser hair removal handle, you should do the following steps:
1.Unscrew 4 fixing screws
Pull out the inner core of the handpiece and remove the welded plate (remove two screws)
Disassemble the CPC water valve connectors
2.Soldering on the hand-insert strip board for easy wiring
3.Welding metal head of conductive wire
4. Mount to the plug head (As picture showed)
The left side (black line) is the laser negative line, and the right side (red line) is the laser positive line.
5.TEC, switch and technical small board wiring
1 (black line) corresponds to the 26th of the rack end (tec negative line)
2 (red line) corresponds to the 27th of the rack end (tec positive line)
4 (black line) corresponds to the 19th of the rack end (switch negative line)
5 (red line) corresponds to the 20th of the rack end (switch positive line)
7,8,9,10 welding count small plate line
6.Install the Water Valve and install the installed black terminal block to the plug
7.Installation of water pipes
The orange-red tube is the inlet pipe (on the positive line side)
The transparent tube is the outlet pipe (on the negative line side)
Finally we have finished the removing of the plug when repairing the diode laser hair removal handle.
Any more questions you can contact Danny whatsapp 0086-18518945778