Alma laser bar description:
This VS-MI-60-12-Alma-Soprano-A is Alma Soprano 12 bar laser stack with PEEK side plate. The electrodes are on the back of the stack.
It is used for Alma Soprano handle piece repairing and replacement.
Oriental-laser focused on diode laser bar assembling for more than 16 years and we have seen various alma soprano diode laser stacks. Also we can use the same Jenoptik bar like Alma used to recondition the power of the alma lasers.
Alma laser bar Repairing procedure
>Choice A: Send the old broken handpiece to our factory. We will do the process of checking , repairing, cleaning and etc. Then send the fresh new handpiece back to you.
>Choice B: if you have basic assembly capacity, you can send the diode laser stack only to our factory. We remove the old bar and mount the new bar to recover the laser power of the stack.
>Choice C: Measure your stack and confirm the water pipe hole and screw hole position. Then press the button below to buy a ready-made stack which is match your old handpiece.
Alma laser bar repair Advantages
>Save Money. Replace the broken diode stack only. Low cost and convenient
>Long lifetime. we use diode laser bars from Germany. The newest Ausn mounting technology will be applied when repairing. After repair. The handpiece will be as a new one. lifetime is much longer than before
All technical support available. We major in diode laser mounting, software, spare parts over 16 years. All the technologies about laser hair removal machine are open to you.
Alma laser bar Specification
| Model No | VS-MI-60-12-AlmaSoprano-A |
| Application | Alma Soprano Handle Piece Repair And Replacement |
| Operation Mode | CW |
| Number of submounts | 12 Bars |
| Power per submounts | 100W |
| Central wavelength at 25℃ | 808 ± 5nm |
| Typical Operation current | 90A |
| Typical Threshold current | 15A |
| Maximum Operating Voltage | 24V |
| Fast Axis Divergence (FWHM) | 39º |
| Slow Axis Divergence (FWHM) | 8º |
| Expected lifetime | >10000 Hours |
| Typical pitch per bar | 1.8mm |
| Cooling | |
| Flow rate | 0.3L/min ±10% / Bar |
| Water Temperature | 25+-3°C |
| Water Quality | Deionized 2-10 µs/cm, mixed bed ion exchanger,particle filter<25µm |
| cooling system | Do not use any material that combination with copper would form galvanic elements |
Alma laser bar Dimension
Alma laser bar Applications:
Any more questions please kindly contact Danny whatsapp 0086-18518945778.
