600W laser diode bar module for alma laser similar hair removal machine

600W laser diode bar module details:

This VS-MI-100-6-Alma stack is for 600W laser diode bar module repairing and replacement service. Please find the details in the following:

Oriental-laser focused on diode laser bar assembling for more than 16 years and we have seen various alma soprano diode laser stacks.Also we can use the same Jenoptik bar like Alma used to recondition the power the laser soprano power. And also we can repair other brand like Zema laser, Aroma Laser and also any china branded.

600W laser diode bar module repairing service procedure

>Choice A: Send the old broken handpiece to our factory. We will do the process of checking , repairing, cleaning and etc. Then send the fresh new handpiece back to you.

>Choice B:  if you have basic assembly capacity, you can send the diode laser stack only to our factory. We remove the old bar and mount the new bar to recover the laser power of the stack.

>Choice C: Measure your stack and confirm the water pipe hole and screw hole position. Then press the button below to buy a ready-made stack which is match your old handpiece.

600W laser diode bar module repairing service Advantages

>Save Money. Replace the broken diode stack only. Low cost and convenient

>Long lifetime.  we use diode laser bars from Germany also we have laser bar from USA dilas and Coherent.The newest Ausn mounting technology will be applied when repairing. After repair. The handpiece will be as a new one. lifetime is much longer than before

All technical support available. We major in diode laser mounting, software, spare parts over 16 years. All the technologies about laser hair removal machine are open to you.


600W laser diode bar module Specification

Model No VS-MI-100-6-Alma
Application Diode Laser Handle Piece Repair And Replacement
Operation Mode CW
Number of submounts 6 Bars
Power per submounts 100W
Central wavelength at 25℃ 808 ± 5nm
Typical Operation current 90A
Typical Threshold current 15A
Maximum Operating Voltage 12V
Fast Axis Divergence (FWHM) 39º
Slow Axis Divergence (FWHM)
Expected lifetime >10000 Hours
Typical pitch per bar 1.8mm
Flow rate 0.3L/min ±10% / Bar
Water Temperature 25+-3°C
Water Quality Deionized 2-10 µs/cm, mixed bed ion exchanger,particle filter<25µm
cooling system Do not use any material that combination with copper would form galvanic elements

600W laser diode bar module Dimension:

Any more question please kindly add my whatsapp 0086-18518945778

Leave a Reply

Your email address will not be published.