Sunday, July 21, 2024
Home808nm Diode Laser Stack300W macro channel laser diode replacement service

300W macro channel laser diode replacement service

300W macro channel laser diode description:

This VS-MA-50-6-B-808 is an 808nm diode laser stack, which has 6 pcs bars mounted on an big cooper heatsink. This stack has an aluminum shell. Electrodes are on the back of the stack. water holes are on the bottom of the stack.

It is used for 808nm diode laser hair removal handpiece repairing and replacement. Usually in Cheap machine from China. 

Oriental-laser focused on diode laser bar assembling for more than 16 years and we have seen various alma soprano diode laser stacks.Also we can use the same Jenoptik bar like Alma used to recondition the power the laser soprano power.

300W macro channel laser diode Repairing procedure

>Choice A: Send the old broken handpiece to our factory. We will do the process of checking , repairing, cleaning and etc. Then send the fresh new handpiece back to you.

>Choice B:  if you have basic assembly capacity, you can send the diode laser stack only to our factory. We remove the old bar and mount the new bar to recover the laser power of the stack.  

>Choice C: Measure your stack and confirm the water pipe hole and screw hole position. Then press the button below to buy a ready-made stack which is match your old handpiece. 


300W macro channel laser diode repair Advantages

>Save Money. Replace the broken diode stack only. Low cost and convenient

>Long lifetime.  we use diode laser bars from Germany. The newest Ausn mounting technology will be applied when repairing. After repair. The handpiece will be as a new one. lifetime is much longer than before

All technical support available. We major in diode laser mounting, software, spare parts over 16 years. All the technologies about laser hair removal machine are open to you.   

300W macro channel laser diode Dimensions:

300W macro channel laser diode Specification

Model No. VS-MA-50-6-B-808
Application 808nm laser hair removal Handpiece Repair And Replacement
Operation Mode CW
Power per submounts 40W
Number of submounts in one stack 6bars
Central wavelength at 25℃ 808 ± 5nm
Typical Operation current 40A
Maximum Operating current 50A
Typical Threshold current 15A
Maximum Operating Voltage <10V
Fast Axis Divergence (FWHM) 39º
Slow Axis Divergence (FWHM)
Operation Condition non-condensing atmosphere, cleaning room
Expected lifetime 10000 hours
Typical pitch per bar 1.8mm
Cooling requirement
Flow rate >2.5L/min
Water Temperature 25+-3°C
Water Quality Deionized 2-10 µs/cm, mixed bed ion exchanger,particle filter<25µm
cooling system Do not use any material that combination with copper would form galvanic elements


Please enter your comment!
Please enter your name here

Contact Us

Name: Danny.Jin
Email: [email protected]
Whatsapp: 0086-18518945778